Dynamic

Dynamic

T-Slot Plate Dimensions Dynamic & E-Lathe

Procedure to Take Out the Cross Slide on the Dynamic-24”/29” Series Lathe

Procedure to Replace the High Low Gear (Item 87 & 65) on Dynamic 29" Lathe

Procedure to Replace Steady Rest Bearings

Procedure to Replace Gear Box for 17" Series

Procedure to Relocate an ACER Lathe

Procedure to Install the Threading Assistant

Procedure to Install Taper Turning Attachment on Dynamic-24/29SeriesG

Procedure to Install the Scale on the 17" Series Lathe

Procedure to Drain Oil in Lathe

Procedure to Adjust the Backlash of the Crossfeed Leadscrew-(Old)

Procedure to Adjust the Backlash of the Crossfeed Leadscrew- (New)

Power Consumption for ACER Lathes

Oil Pump Pictures for Dynamic & E-Lathe 17" Series

Oil Drainage Hole on Dynamic-1440G

Load Capacity for Dynamic 24 & 29 Lathe

How to Align 17" Series Headstock

How to Align Dynamic-1440G Headstock

How to Adjust the Overload Clutch on the Dynamic-1440G

Gear Rack Dimensions For Dynamic 29" Series

Gear Rack Dimensions For Dynamic & E-Lathe 17" Series

Follow Rest Drawing for Dynamic 29" Series Lathe

Dynamic-2960G Dimensions

Dynamic-24" & 29" Steady Rest Dimensions

Dynamic 24" & 29" Rack & Gear Shaft Dimensions- Inch

Dynamic 24" & 29" Rack & Gear Shaft Dimensions- Metric

ACER Lathe Spindle Info for 5C Collet

ACER Lathe Lubrication Oil Chart

ACER Lathe Accessories- Steady Rest, Follow Rest, Face Plate Dimensions

5C Collet Closer Manual

Powered by E Century